Pelco pelco c1911m Manual de usuario descargar pdf (Pagina 7)

Pelco Manual C1911M (4/98) 7

3.0 INSTALLATION

3.1 MOUNTING

The monitor has rubber feet and may be placed on any horizontal surface, such as

a desk or table.

The monitor also may be installed in a 19-inch (48.26 cm) rack or on a wall, ceiling,

or pedestal mount. Follow the instructions that accompany the rack kit or mount.

3.2 CONNECTIONS

1. Connect a video cable from the video source to the BNC connector labeled

VIDEO IN on the rear panel of the monitor (refer to Figure 1). Refer to Table A

for the type of video coaxial cable to use.

2. When the video signal is looped through the monitor, connect a video cable

from the BNC connector labeled VIDEO OUT to the equipment which requires

a video signal input (refer to Figure 1).

3. Set the termination switch on the monitor to the 75-ohm or OPEN position

(refer to Figure 1).

4. Plug in the power cord.

Table A. Video Coaxial Cable Wiring Distances

Cable Type* Maximum Distance

RG59/U 750 ft (229 m)

RG6/U 1,000 ft (305 m)

RG11/U 1,500 ft (457 m)

*Minimum cable requirements:

75 ohms

All-copper center conductor

All-copper braided shield with 95-percent braid coverage

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Pelco pelco c1911m Manual de usuario Pagina 7